fpv how to install your drone propellers correctly and never forget

In the video I’ll show you how to install your propellers correctly and the way you will NEVER forget how to do it, in this easy to remember fpv propeller installation guide.

drone propeller install and how to install your drone propellers correctly

some general text / info:
Props are designed to produce maximum thrust when turning in only a single direction. Quadcopters are equipped with two sets of two different props: one set of “clockwise” (CW) props which rotate like a clock, and another set of “counter-clockwise” (CCW) props. Normally when you buy props for quadcopters, you receive a full set of 2 CW and 2 CCW props.

You can determine the direction of a prop in one of several ways. Most props have labels on them that look something like “5045” and “5045R”. When labeled like so, the “R” stands for CCW while the lack of an R means the prop is a CW prop.

The better way to determine the intended direction of a prop is to find its leading edge. The leading edge of a propeller blade is the side of the blade that is raised above the other side with a slight concave curve underneath it. All props have this, whether or not they are labeled, so learning to recognize it pays off.

6 Comments

  1. PortEL Gate 9 on May 24, 2021 at 3:03 am

    This doesn’t work if you’re flying props out

  2. Falkon FPV on May 24, 2021 at 3:12 am

    THIS IS THE BEST VIDEO I’VE SEEN TO PUT ON
    PROPS. Thank You

  3. Paulo Mota on May 24, 2021 at 3:28 am

    It works both ways facing towards ou backwards. Great video. Thanks.

  4. Anders Martinson on May 24, 2021 at 3:33 am

    I’ve been flying for about 7-8mo and this actually helps, thanks!!

  5. California_Gaming on May 24, 2021 at 3:45 am

    This is the most weird explanation I’ve seen in all the years I’ve flown quads

  6. Legend Man on May 24, 2021 at 3:52 am

    How far does the screws have to be ? Bc on my drone I got my first one it just leave a bit to put the screw on is that good or no ? M5 self-locking nut and 4032 3-blade Props

Leave a Comment